Configuration Management - Nortel 325-24T Configuration Manual

266 Chapter 7 System configuration using the CLI
The
The

Configuration Management

This section covers the following topics:
•
•
Automatically loading Configuration file
This section discusses how to download a configuration file when the system
boots. You use standard CLI commands to modify the configuration file you want
to download. This section covers these commands:
•
•
configure network command
The
immediately and to configure parameters to automatically download a
configuration file when you reboot the switch or stack. The syntax for the
configure network
configure network [load-on-boot
{disable|use-bootp|use-config}] [filename <WORD>] [address
<XXX.XXX.XXX.XXX>]
The
320985-A Rev 01
default ip domain-name
default ip domain-name
"Automatically loading Configuration file" on page 266
"ASCII Configuration Generator" on page 268
"configure network command"
"show config-network command" on page 267
configure network
command is:
configure network
Note: When you enter
system prompts you for the script file name and TFTP server address and
then downloads the script.
command is in the config command mode.
command has no parameters or variables.
command allows you to load and execute a script
command is in the exec mode.
configure network
with no parameters, the