Port Configuration Screen - Nortel 325-24T Configuration Manual

Port Configuration screen

The Port Configuration screen (Figures
specific switch ports or all switch ports. You can enable or disable the port status
of specified switch ports, set the switch ports to autonegotiate for the highest
available speed of the connected station, or set the speed for selected switch ports
(autonegotiation is not supported on fiber optic ports).
You can disable switch ports that are trunk members (except the lowest member
of an active trunk which cannot be disabled until it is removed from the MLT);
however, the screen prompts for verification of the request before completing the
action. Choosing Yes disables the port and removes it from the trunk.
Note: You cannot disable a port that is a member of the MLT if the
switch is operating in the RSTP/MSTP mode.
Note: The Autonegotiation fields, the Speed fields, and the Duplex
fields are independent of MultiLink Trunking, VLANs, and the STP.
To open the Port Configuration screen:
➨
Choose Port Configuration (or press p) from the Switch Configuration
Menu screen.
Chapter 2 Using the console interface
22 and 23) allows you to configure
System Configuration Guide
109