Ip Bootp Server Command - Nortel 325-24T Configuration Manual

The command is in the privExec command mode.
boot
Table 75 describes the parameters and variables for the
Table 75 boot command parameters and variables
Parameters and
Description
variables
default Restores switch or stack to factory-default settings after rebooting.
Note: When you reset to factory defaults, the stack operational mode,
last reset count, and reason for last reset will not be set to factory
defaults.

ip bootp server command

The
ip bootp server
the switch or server. The syntax for the
ip bootp server {last|needed|disable|always}
The
ip bootp server
Table 76 describes the parameters and variables for the
command.
Table 76 ip bootp server command parameters and variables
Parameters and
variables
last|needed|disable|
always
Chapter 7 System configuration using the CLI 275
command configures BootP on the current instance of
ip bootp server
command is in the config command mode.
Description
Specifies when to use BootP:
• last—use BootP or the last known address
• needed—use BootP only when needed
• disable—never use BootP
• always—Always use BootP
command.
boot
command is:
ip bootp server
System Configuration Guide