Quick Start - Nortel 325-24T Configuration Manual

Quick Start

The Quick Start feature allows the administrator of the Ethernet Switch 325/425
to make the initial setup by consolidating multiple setup pages into a single page.
The Quick Start screen will allow the administrator to configure the following
information:
•
•
•
•
•
•
•
During the initial setup mode, all ports in the switch or stack are assigned to the
new default VLAN.
A port-based Quick Start VLAN is created if the new default VLAN does not
exist. All ports are removed from the current default VLAN and assigned to the
Quick Start VLAN. The PVIDs for all ports are changed to the Quick Start
VLAN. The Quick Start VLAN is also designated as the management VLAN.
To configure the initial settings using the Quick Start feature:
1
Chapter 11 Administering the switch using Web-based management
Switch/Stack IP address
Subnet mask
Default gateway
SNMP Read community
SNMP Write community
SNMP Trap IP addresses and communities (up to four)
New default VLAN
From the main menu, select Administration > Quick Start.
The Quick Start page is displayed (Figure 152).
System Configuration Guide
377