The Trigger Modes - Fluke CombiScope PM3370B User Manual

USING THE COMBISCOPE INSTRUMENTS
3.4.1.3

The trigger modes

A combination of the INITiate:CONTinuous and TRIGger:SOURce command
allows you to define the following trigger modes:
Trigger mode:
>>>Single-shot<<<
Generates one sweep, regardless of any
trigger settings (valid after
>>>Single-shot<<<
Generates one sweep, triggered using
trigger settings.
>>> Single-shot <<<
Generates one sweep, externally triggered
via channel 4 (only for PM33x0B).
>>>Auto trig<<<
Generates continuous sweeps,
independent of any trigger settings.
>>>Normal trig<<<
Generates continuous sweeps, triggered
using trigger settings.
>>> Normal trig <<<
Generates continuous sweeps, externally
triggered via channel 4 (only for PM33x0B).
>>>Single-Shot<<<
Generates one sweep triggered by
or GET, regardless of any trigger settings.
RST).
*
TRG
*
Table 3.1 The TRIGger modes
INITiate
:CONTinuous
OFF
OFF
OFF
ON
ON
ON
ON
or
OFF
3 - 25
TRIGger
:SOURce
IMMediate
INTernal<n>
or
LINE
EXTernal
IMMediate
INTernal<n>
or
LINE
EXTernal
BUS