Fluke CombiScope PM3370B User Manual page 206

4 - 106
Limitations:
For the PM33x0B CombiScope instruments:
- Input channel 3 (CH3) is not applicable.
- Input channel 4 (CH4) is limited to external trigger view.
Example:
→
Send SYSTem:SET? 32
←
Read <curs_setup>
→
Send SYSTem:SET?
←
Read <settings>
.
.
→
Send SYSTem:SETSP
→
Send <settings>
Programming tip:
The number of <settings> bytes can be determined from the second byte of the
returned <settings> information itself. A node is always built up as follows:
<node_nr> <node_length> <first_byte> ... <last_byte>
The second <node_length> byte indicates the number of bytes to follow.
If no <node_nr> was specified the number of bytes must be determined while
reading the <settings>.
Front panel compliance:
The SYSTem:SET? query followed by the SYSTem:SET command gives a
remote possibility to save and recall complete or partial instrument setups.
COMMAND REFERENCE
Queries for cursor instrument settings.
Reads cursor instrument settings.
Queries for all instrument settings.
Reads all instrument settings.
Sends the header plus a space without
message termination (EOI off).
Sends all instrument settings, plus
message termination (EOI on).