Fluke CombiScope PM3370B User Manual page 285

SUMMARY OF SYSTEM SETTINGS
65 | 66 MATH1/2 settings
MATH1/2 selection, limited on/off, FFT filter
Hamming/Hanning/Rectangle, adjustify scale/offset,
source1/source2, Y-cursors/X-cursors, mathematics type add,
subtract, multiply, filter, integrate, differentiate, fast fourier,
histogram, source MATH1/2 CHn, Mi_j, scale, offset, filter window
width, differentiate window width, FFT area left/right border, Y-
offset integrate limited area, FFT absolute/relative readout.
80 Display settings
settings display on/off, ground and trigger level indication on/off,
dots join on/off, X versus Y on/off, status view on/off, window on/off,
menu number, menu on/off, hold-off time, trace separation, X
source (X versus Y mode), display_trace definition 1 to 8, sine
wave interpolation on/off.
81 Trace intensity settings
analog trace intensity, mtb/dtb intensity ratio.
Display trace position settings
82
display_y_pos trace 1 to 8, display_x_pos trace 1 to 8.
96 Setup label text (22 characters)
setup label text characters.
Autorange settings
112
auto time base on/off, auto attenuation CH1/2/3/4 on/off, degrees
mode on/off, 4-stroke/normal mode, auto time base degrees/time
factors.
128 Real-time clock settings
clock format selection.
240 Service (factory) settings
auto/manual_cal adjustments.
E - 3
length = 22 bytes
length = 27 bytes
length = 5 bytes
length = 34 bytes
length = 24 bytes
length = 8 bytes
length = 3 bytes
length = 5 bytes