Fluke CombiScope PM3370B User Manual page 283

SUMMARY OF SYSTEM SETTINGS
APPENDIX E
SUMMARY OF SYSTEM SETTINGS
The following table identifies which instrument settings belong to which node.
NODE NR: SPECIFICATION:
0 End node settings
zero
Channel 1/2/3/4 settings
1 | 2 | 3 | 4
attenuation, channel on/off, input coupling DC/AC/grounded, invert
on/off,
continuous/discrete, Y_offset_position.
14 Probe scale settings
probe_correction_factors CH1/2/3/4, probe_scale bits, probe_unit
CH1/2/3/4, probe_scale_factors CH1/2/3/4.
15 Common vertical settings
add CH1+CH2, add CH3+CH4, display mode alternate/chopped,
automatic display on/off, bandwidth limiter on/off, averaging on/off,
envelope mode on/off, averaging factor, vertical magnify factor.
Horizontal settings
16
x-deflection on/off, reset on/off, acquisition lock on/off, scope mode
digital/analog, peak detection on/off, horizontal mode: auto,
triggered,
CH1/2/3/4/line, digital magnify factor + analog magnify on/off,
acquisition length factor, x-position.
Main timebase settings
17
timebase, trigger mode: edge, TV, pattern, state, glitch, intensified
on/off, main timebase on/off, trigger slope pos/neg, TV trig mode
field1/field2/line, noise suppression on/off, mtb mode continuous
(var. steps)/discrete (1-2-5 steps), peak-peak trig on/off, triggered
on/off, armed on/off, Vpp trig slope, roll mode stop on
trig/continuous, autoset trigger gap on/off, roll mode on/off, real-
time only on/off, dual slope triggering on/off, trigger level, trigger
source CH1/2/3/4, composite, line, external, trigger delay value,
trigger coupling AC, DC, LF reject, HF reject, TV-system PAL,
HDTV, NTSC, SECAM, pattern glitch condition ENTER, EXIT,
RANGE, >T1, <T2, trigger pattern CH1/2/3/4, TV line number,
pattern/glitch trigger time T1/2.
input impedance
single-shot,
50Ω/1MΩ,
multiple-shot, x-deflection
E - 1
length = 1 byte
length = 8 bytes
attenuation mode
length = 24 bytes
length = 6 bytes
length = 9 bytes
source
length = 26 bytes