4 - 122
TRIGger[:SEQuence[1]]:SLOPe
TRIGger[:STARt]:SLOPe
Syntax:
TRIGger[:SEQuence[1]]:SLOPe POSitive | NEGative | EITHer
Alias:
TRIGger[:STARt]:SLOPe POSitive | NEGative | EITHer
POSitive
NEGative
EITHer
Query form: TRIGger[:SEQuence[1]]:SLOPe?
TRIGger[:STARt]:SLOPe?
Response:
POS | NEG | EITH
POS
NEG
EITH
Description:
Controls the trigger edge (slope) to be detected. The command sets the trigger
slope and the query returns the trigger slope. The dual slope mode (EITHer) is
only possible, if the following selections are valid:
-
the digital mode
-
the real-time mode
-
the 'single-shot' mode
-
the trigger source is INTernal
After a
RST command, the trigger slope is POSitive.
*
Positive trigger edge.
Negative trigger edge.
Triggering is done at a positive and at a negative
edge.
Positive trigger edge.
Negative trigger edge.
Trigger edge is both positive and negative.
INSTrument DIGital
SENSe:SWEep:REALtime ON
INITiate:CONTinuous OFF
TRIGger:SOURce INTernal1|2|3|4
COMMAND REFERENCE