Fluke CombiScope PM3370B User Manual page 167

COMMAND REFERENCE
MEASure?
Syntax: MEASure[:VOLTage]<measure_function>?
<voltage_parameters> =
<channel_list> =
<measure_function>
:AC
:AMPLitude
[:DC]
[[ (<voltage_parameters>),] <measure_parameters>]
<expected_voltage> = <NRf> | DEFault
Specifies the voltage that is expected at the input.
<resolution> = <NRf> | DEFault
This parameter may be added for reasons of
compatibility
instruments. It would specify the resolution of the result
when a voltage measurement is to be executed.
Because the CombiScope has a fixed resolution, this
parameter is ignored during execution.
Both voltage parameters must be omitted when the
:VOLTage node of the command is defaulted.
Specifies the input channel number at which the
characteristic is to be measured.
Note: @3 and @4 not applicable for PM33x0B.
<measure_parameters>
No parameters. Measures the RMS value of the AC
component. The RMS value is expressed in volts.
No parameters. Measures the amplitude of a waveform.
The amplitude is the difference between the HIGH and
LOW values as shown in figure 3.2. The amplitude is
expressed in volts.
No parameters. Measures the DC component. The DC
component is expressed in volts.
[<expected_voltage> [,<resolution>]]
with similar programs
[(@1)] | (@2) | (@3) | (@4)
4 - 67
[,<channel_list>]
for other