Path Contours Cartesian Coordinates; Straight Line - HEIDENHAIN TNC 370 User Manual

5 Programming Tool Movements
L
1
5.4 Path Contours - Cartesian Coordinates
L
Straight line
L
To program a straight line, you enter:
l
The coordinates of the end point @
l
If necessary:
Radius compensation, feed rate, miscellaneous function
The tool moves in a straight line from its starting position @ to the end
point 0. The starting position was reached in the previous block.
/
0
Fig. 5.15: A linear movement
To program a straight line
e.g.
X
\
/
e.g. 0 0
0
Identify coordinates as relative values.
Select the axis (by soft key or alphabetic keyboard), for example X.
Enter the coordinate of the end point.
If a coordinate is negative, press the - key once, for example
IX=-50 mm.
Enter all further coordinates of the end point
After entering all coordinates, close the dialog with the ENT key