•
To prevent any RIP packets from being transmitted
CLI Example
The configuration commands used in the following example enable RIP on ports 1/0/2 and 1/0/3 as
shown in the network illustrated in
Figure 5-4
Example #1: Enable Routing for the Switch:
The following sequence enables routing for the switch:
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
IP Routing Services
NETGEAR 7000 Series Managed Switch Administration Guide
Figure 5-4
v1.1, May 2006
5-13