Undo Exec - Ricoh Z-P2 Field Service Manual

2. Installation
3. Insert the SD card (having stored the application program) in SD card slot 2. The
application program is copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 "Move Exec".
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD card slot 2.
10. Turn the main switch on.
11. Check that the application programs run normally.

Undo Exec

The menu "Undo Exec" (SP5-873-002) lets you copy back application programs from an SD card to
the original SD card. You can use this program when, for example, you have mistakenly copied some
programs by using Move Exec (SP5-873-001).
• Do not turn ON the write protect switch of an application SD card on the machine. If the write
protect switch is ON, a download error (e.g. Error Code 44) occurs during a firmware upgrade or
application merge.
1. Turn the main switch off.
2. Insert the original SD card in SD card slot 2. The application program is copied back into
this card.
3. Insert the SD card (having stored the application program) in SD card slot 1. The
application program is copied back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec".
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD card slot 2.
• This step assumes that the application programs in the SD card are used by the machine.
10. Turn the main switch on.
11. Check that the application programs run normally.
82