Ricoh Z-P2 Field Service Manual page 551

Module mismatch – Module on SD
35 card is not for this machine
Cannot write module – Cause other
36 than E34, E35
The version of the downloaded
program error
38
Engine module download failed
40
Controller module download failed
44
Firmware updating is currently
prohibited.
49
Electronic confirmation check failed
50
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
The version of the downloaded program has not
been authorized for the update.
Make sure that the program for updating is the
specified version.
Replace the update data for the module on the SD
card and try again, or replace the BCU.
Replace the update data for the module on the SD
card and tray again, or replace controller board.
The setting of Update Firmware in the Administrator
Tools has been set to [Prohibit] by an administrator.
Change the setting to [Do not Prohibit] and try
again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
Firmware Update
549