Ricoh Z-P2 Field Service Manual page 302

5. System Maintenance Reference
2-109-006 Density: Bk
2-109-007 Density: C
2-109-008 Density: M
2-109-009 Density: Y
2111 [Line Pos. Ajust]
2-111-001 Mode a
2-111-002 Mode b
2-111-003 Mode c
2-111-004 Mode d
2112 [TM/P-Sensor Test] FA
2-112-001 Execute
2117 [Skew Adjustment] Skew Adjustment Input
Specifies a skew adjustment value for the skew motor M, C or Y.
300
ENG Specifies the color density for the test
pattern.
ENG
[0 to 15 / 15 / 1 /step]
ENG
0: Lightest density
15: Darkest density
ENG
ENG Executes the fine line position adjustment
twice.
If this SP is not completed (NG is
displayed), do SP2111-003 first and then
try this SP again.
ENG Executes the fine line position adjustment
once.
If this SP is not completed, do
SP2111-003 first and then try this SP
again.
ENG Executes the rough line position adjustment
once.
After doing this SP, make sure to execute
SP2111-001 or -002. Otherwise, the line
position adjustment is not perfectly done.
ENG Executes the rough adjustment and fine
adjustment, once each.
ENG This SP is used to check the ID sensors at
the factory. The results of this SP are
displayed in SP2140 to SP2145.