Ricoh Z-P2 Field Service Manual page 457

5840 [IEEE 802.11]
5-840-006 Channel MAX
5-840-007 Channel MIN
5-840-011 WEP Key Select
5-840-045 WPA Debug Lvl
*CTL Sets the maximum number of channels available
for data transmission via the wireless LAN. The
number of channels available varies according
to location. The default settings are set for the
maximum end of the range for each area. Adjust
the upper 4 bits to set the maximum number of
channels.
EU: [1 to 13 / 13 / 1/step]
NA: [1 to 11 / 11 / 1/step]
AS: [1 to 14 / 14 / 1/step]
*CTL Sets the minimum number of channels available
for data transmission via the wireless LAN. The
number of channels available varies according
to location. The default settings are set for the
minimum end of the range for each area. Adjust
the lower 4 bits to set the minimum number of
channels.
EU: [1 to 13 / 1 / 1/step]
NA/ AS: [1 to 11 / 1 / 1/step]
AS: [1 to 14 / 14 / 1/step]
*CTL Selects the WEP key.
[00 to 11 / 00 / 1 binary /step]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
*CTL Selects the debug level for WPA authentication
application.
[1 to 3 / 3 / 1 /step] 1: Info, 2: warning, 3:
error
This SP is displayed only when the IEEE802.11
card is installed.
Engine SP Mode Tables - SP5000
455