Undo Exec - Ricoh J-P3 Service Manual

SD CARD APPLI MOVE

5.5.3 UNDO EXEC

The menu "Undo Exec" (SP5-873-002) enables you to copy back application
programs from an SD card to the original SD card. You can use this program when,
for example, you have mistakenly copied some programs by using Move Exec
(SP5-873-001). The application programs are copied as follows:
• From slot 1 to slot 2 when SD cards are in slots 1 and 2 or in all slots
• From slot 1 to slot 3 when SD cards are in slots 1 and 3
Note that the authentication data is also copied with the application program (☛
5.5.1).
1. Turn off the main power switch.
2. Insert the original SD card in slot 2. The application program is copied back to
this card.
NOTE: You can insert the original SD card in slot 3. If you do this, remove the
SD card from slot 2 if there is one there.
3. Insert the SD card (having stored the application program) to slot 1. The
application program is copied back from this SD card.
4. Turn on the main power switch.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec."
7. Follow the messages displayed on the operation panel.
8. Go out of the SP mode.
9. Turn off the main power switch.
10. Remove the SD card from slot 3.
11. Remove the other SD card from slot 1.
12. Insert the necessary SD card in slot 3. If two SD cards are necessary, insert
them in slots 2 and 3.
13. Turn on the main power switch.
14. Check that the application programs run normally.
5-84
20 February 2004