Ricoh Z-P2 Field Service Manual page 403

3-043-003 Rept Nmbr:Non-use
Specifies the maximum number of repeats of the toner density adjustment in stand by
mode.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and
toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
3-043-004 Repeat Number: ACC
Specifies the maximum number of repeats of the toner density adjustment at ACC.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and
toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
3-043-005 Rept Nmbr:Recvry
Not used
3-043-006 Rept Nmbr:Job End
Specifies the maximum number of repeats of the toner density adjustment at job end.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and
toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
3-043-007 Rept Nmbr:Intrrpt
Specifies the maximum number of repeats of the toner density adjustment during
printing. DFU
Engine SP Mode Tables - SP3000
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 4 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
401