Remarks; Display On The Control Panel Screen - Ricoh Z-P2 Field Service Manual

5. System Maintenance Reference
• To make the settings effective, turn the main switch off and on after exiting service mode.

Remarks

Display on the Control Panel Screen

Since the maximum number of characters which can be displayed on the control panel screen is limited
(12 or 17 characters), the description of SP modes displayed on the screen needs to be abbreviated.
The following are the major abbreviations used for the SP modes for which the full description is over 12
or 17 characters.
1. Paper Type
N: Plain paper 1, N2 or Normal 2: Plain paper 2 (plain & recycled)
TC: Thick paper, Thick 1: Thick paper 1, Thick 2: Thick paper 2
TN: Thin paper
SP: Special paper
2. Color Mode [Color]
[K]: Black in B&W mode
[Y], [M], or [C]: Yellow, Magenta, or Cyan in Full Color mode
[YMC]: Only for Yellow, Magenta, and Cyan
[FC], [Cl]: Full Color mode
[FC, K], [FC, Y], [FC, M], or [FC, C]: Black, Yellow, Magenta, or Cyan in full color mode
3. Process Speed
LS: Low speed xx
RS: Regular speed xxx
HS: High speed xxx
As shown in the following table, the process speed (mm/s) depends on the print mode (B&W or Color),
resolution, and/or type of paper selected. Some SP mode settings depend on the process speed.
Mode
Plain Paper
254
Resolution (dpi)
600 x 600
1,200 x 1,200
Line speed (mm/s)
260
85
Print speed (ppm)
40
15