Undo Exec - Ricoh G108 Service Manual

SD CARD APPLI MOVE

5.3.3 UNDO EXEC

Slot 1 refers to the upper SD-card slot [A]. Slot 2
refers to the lower SD-card slot [B].
The service program "Undo Exec" (Engine SP5-
873-002) allows you to copy application programs
from an SD card back to the original SD card. You
should use this program if you have mistakenly
copied some programs by using Move Exec
(Engine SP5-873-001). The application programs
are copied from the SD card in Slot 1 to the SD
card in Slot 2. Note that the authentication data is
also copied with the application program (
1. Turn off the main power switch.
2. Prepare the original SD card.
3. Turn the SD card face [C] to the left side of the
machine. Then insert it into Slot 2. The
application program is copied back to this card.
4. Prepare the SD card that has stored the
application program.
5. Turn the SD card face [D] to the left side of the machine. Then put it into Slot 1.
The application program is copied back from this SD card.
6. Turn on the main power switch.
7. Enter SP mode.
8. Select Engine SP5-873-002 "Undo Exec."
9. Follow the instruction on the operation panel.
10. Exit SP mode.
11. Turn off the main power switch.
12. Remove the SD card from Slot 2.
13. Remove the other SD card from Slot 1.
14. Insert the necessary SD card to Slot 2.
15. Turn on the main power switch.
16. Check that the application programs operate correctly.
G108
5.3.1).
[D]
[C]
5-46
[A]
[B]
G108S904.WMF
SM