Ricoh Z-P2 Field Service Manual page 471

5-930-001 -
Switches the meter-click charge mode on and off.
[0: OFF], [1: ON]
Important: Turn the main switch off/on after changing this setting.
OFF:
Meter charge mode disabled (default). This setting is for machines were the operator
is responsible for replacing the PCDU, the ITB unit, and the fusing unit.
Alert messages are displayed on the operation panel when the PCDU, the ITB unit,
and the fusing unit reach the limit of their yield.
ON:
Meter charge mode enabled. This setting is for machines which the service technician
has responsibility for servicing.
• Alert messages are not displayed when the PCDU, the ITB unit, and the fusing
unit reach the limits of their yield.
• If the setting of SP5-930-001 is set to "1 (enabled)", the settings of
SP5-930-010, -014 and -016 must be adjusted.
5-930-010 PCDU
5-930-014 Mid Trans Unit
5-930-016 Fusing Unit
5987 [Mech. Counter]
*ENG -
*ENG Displays or does not display the end display
for the PCDU. This SP is activated only when
the SP5930-001 is set to "1".
[0 or 1 / 1 / - /step]
0: OFF, 1: ON
*ENG Displays or does not display the end display
for the ITB unit. This SP is activated only when
the SP5930-001 is set to "1".
[0 or 1 / 1 / - /step]
0: OFF, 1: ON
*ENG Displays or does not display the end display
for the fusing unit. This SP is activated only
when the SP5930-001 is set to "1".
[0 or 1 / 1 / - /step]
0: OFF, 1: ON
Engine SP Mode Tables - SP5000
469