Ricoh Z-P2 Field Service Manual page 267

bit 4 Add "Apply Auto Paper Select" is the condition
that decides if the device's paper size or paper
type should be overwritten.
If this Bit Switch is set to "1" (enable), the "Apply Auto Paper Select" setting will
decide if the paper size or paper type that is specified in the device settings should
be overwritten by the job's commands when "Tray Setting Priority" is set to "Driver/
Command" or "Any Type".
- Apply Auto Paper Select = OFF: Overwritten (priority is given to the job's
commands)
- Apply Auto Paper Select = ON: Not overwritten (priority is given to the device
settings)
bit 5 DFU
bit 6 DFU
bit 7 DFU
1001 Bit Switch
012 Bit Switch C DFU
1003 [Clear Setting]
1003 001 Initialize System
1003 003 Delete Program
1004 [Print Summary]
1004 001 Service Summary
1005 [Display Version]
1005 002 Printer Version
1007 [Supply Display]
Enables or disables the display for information on each consumable supply.
0: Disable
Initializes settings in the System menu of the user
mode.
DFU
Prints the service summary sheet (a summary of all
the controller settings).
Displays the version of the controller firmware.
Service SP Mode Tables
1: Enable
- -
- -
- -
- -
265