Ford 2003 Mustang Workshop Manual page 4094

Hide thumbs Also See for 2003 Mustang:
Table of Contents

Advertisement

SECTION 501-20B: Supplemental Restraint System
GENERAL PROCEDURES
Weld Nut Repair —Missing Weld Nut, Restraints Control
Module (RCM)
WARNING: To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before repairing or replacing any front or side air bag
supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel,
console, door latches, strikers, seats and hood latches.
Please refer to the appropriate vehicle shop manual to determine location of the front air bag
sensors.
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at
least one minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
NOTE: There are two procedures to repair a vehicle having missing restraints control module attaching
weld nut(s). Read both procedures before proceeding with the repair.
NOTE: If two or more weld nuts are missing, do not install the "J" nuts as outlined in Weld Nut Repair
— "J" Nut, Restraints Control Module (RCM). Weld nuts must be installed as outlined in this
procedure.
NOTE: Radiator support repair shown, others are similar.
1. Obtain a 6 mm (0.24 in) weld nut (part number N806285-S190).
2. Obtain a 6 mm (0.24 in) grounding screw (part number N806327-S190).
3. Route a sufficient length of copper welding wire through the weld nut clearance hole and back
out an adjacent access hole.
4. Feed the copper welding wire through the weld nut, then through a standard flatwasher.
2003 Mustang Workshop Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents