5. NOTE: Make sure the wheels (1007) are in the straight-ahead position.
Remove the steering wheel (3600). For additional information, refer to
6. Apply two strips of masking tape across the clockspring (14A664) to prevent accidental rotation
when the clockspring is removed.
7. Remove the lower steering column shroud (3530).
1. Remove the tilt wheel handle and shank (3F609).
2. Remove the four screws.
3. Remove the lower steering column shroud.
8. Remove the ignition switch lock cylinder (11582).
1. Position the ignition switch lock cylinder to the RUN position.
2. Using the suitable tool, push upward on the cylinder release tab while pulling the ignition
switch lock cylinder outward.
Section 211-04
.