Ford 2003 Mustang Workshop Manual page 4100

Connect the RCM.
1. Position the RCM.
2. Install the bolts.
3. Connect the RCM electrical connector.
4. Slide and engage the RCM electrical connector locking clip.
5. Reposition the carpet.
2. Install the RCM.
1. Install the bolt.
2. Reposition the carpet.
3. Connect the battery ground cable. For additional information, refer to
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the
supplemental restraint system (SRS). For additional information, refer to
Restraint System (SRS)
5. Disconnect the battery ground cable and wait at least one minute. For additional information,
refer to Section 414-01
6. Restore the vehicle to operating condition.
1. WARNING: To reduce the risk of serious personal injury, read and follow all
warnings, cautions, notes, and instructions in the supplemental restraint system
(SRS) deactivation/reactivation procedure.
Reactivate the supplemental restraint system (SRS). For additional information, refer to
Supplemental Restraint System (SRS) Deactivation and Reactivation
Procedures portion of this section.
2. WARNING: The restraint system diagnostic tool is for restraint system
service only. Remove from the vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental
restraint system (SRS). For additional information, refer to
in the Diagnosis and Testing portion of this section.
.
Section 414-01 .
Air Bag Supplemental
in the General
Air Bag Supplemental