Ford 2003 Mustang Workshop Manual page 4099

and wait at least one minute. Be sure to disconnect auxiliary batteries and power
supplies (if equipped).
Disconnect the battery ground cable (14301) and wait at least one minute. For additional
information, refer to
2. WARNING: To reduce the risk of serious personal injury, read and follow all
warnings, cautions, notes, and instructions in the supplemental restraint system
(SRS) deactivation/reactivation procedure.
Deactivate the supplemental restraint system (SRS). For additional information, refer to
Supplemental Restraint System (SRS) Deactivation and Reactivation
Procedures portion of this section.
2. Remove the right hand restraints control module (RCM) bracket retaining bolt.
1. Position the carpet back at the right hand side of the instrument panel (I/P) center
support bracket.
2. Remove the RCM bracket retaining bolt.
3. Remove the RCM with bracket.
1. Position the carpet back at the left hand side of the I/P center support bracket.
2. Disengage the RCM electrical connector locking clip.
3. Disconnect the RCM electrical connector.
4. Remove the two retaining bolts.
5. Remove the RCM with bracket.
Installation
WARNING: To reduce the risk of serious personal injury, read and follow all warnings,
cautions and notes at the beginning of the removal procedure.
1. WARNING: The tightening torque of the air bag restraints control module (RCM)
retaining bolts is critical for correct system operation.
Section 414-01 .
in the General