Ford 2003 Mustang Workshop Manual page 1557

Hide thumbs Also See for 2003 Mustang:

Table of Contents

NOTE: Lubricate the piston rings, cylinder walls and connecting rod bearings with clean engine

Using the special tool push the pistons through the top of the cylinder block.

CAUTION: Do not scratch the cylinder walls or the crankshaft journals with the

connecting rod.

NOTE: Make sure the crankshaft is at top dead center (TDC).

Using the special tool, install the connecting rod assemblies.

15. NOTE: The rod bearing cap bolts are torque-to-yield. Install new bolts, each time they are

Install the connecting rod bearing caps and bolts. and tighten in three stages.

Stage 1: Tighten to 25 Nm (18 lb-ft).

Stage 2: Tighten to 45 Nm (33 lb-ft).

Stage 3: Tighten an additional 90 degrees.

Show Quick Links

Table of Contents