The Relationship Between The Feedback Signal And The Measured Value (Pv) Of Pid Control - Panasonic VF200 Instruction Manual

Appendix Function Parameter List
■ The relationship between the feedback signal and the measured value
(PV) of PID control
nd
(When parameter "P124: The 2 Analog Input Function Select" is set to "1".)
・The frequency exceeding the maximum frequency or the upper frequency
limit will not be output.
Also, the frequency will not drop below the lower frequency limit.
nd
・The inverter will not perform reverse run operation even if the 2
frequency
setting signal input is a negative value.
Feedback signal of PID control for negative values is 0%.
nd nd
・The 2
bias frequency and the 2 gain frequency have no connection with
the setting values of bias/gain function select (parameter P102).
Related parameters: P005, P008, P036 to P040, P124, P125, P106 to P111
242