3-Wire Stop Command Function; Pulse Counter Input Function - Panasonic VF200 Instruction Manual

Appendix Function Parameter List

■ 3-wire Stop Command Function

Signal input terminal for executing 3-wire stop command can be set.
When "3-wire stop signal" is ON, "run signal" or "forward/reverse run
operation" can be held automatically. Also, switching to OFF will cancel the
holding status.
・Please set "Run Command Select" (parameter P003).
・The input signal of 3-wire stop command is "contact B input".
(regardless of "P041: Input Logic Setting")
Related parameter: P003

■ Pulse Counter Input Function

The function can be set during multi-speed operation by inputting pulses
(P045 = 5, 6). Pulse input signal is sent to SW2 (terminal No.5) and number of
pulses is counted up.
The function is valid when setting of "P045: Multi Speed Function Select" is "5"
or "6".
Count the number of OFF→ON rising edges.
・For details of pulse input during multi speed operation, read "P045: Multi
Speed Function Select" carefully before using the function. (Refer to P.165)
Related parameters: P001, P002, P045 to P052, P061 to P066, P079 to P086
182