To Display Or Conceal Built-In Memory Setting Mode - Panasonic VF200 Instruction Manual

8.6 To Display or Conceal Built-in Memory
Setting Mode
For determining whether to display built-in memory setting mode or not. When
copy function is unused, make setting to "conceal" for simplified operation. To
display built-in memory setting mode, change the setting value to "E2P"; to
conceal built-in memory setting mode, change the setting value to "OFF".
To conceal built-in memory setting mode
button to stop the inverter.
1. Press
2. Press button four times.
(If a password is set beforehand, please enter it. Refer to
parameter P150. )
3. Press button.
／
4. Press
5. Press button.(Display the current settings.)
6. Press button to change the displayed value to "OFF".
7. Press button.
8. Press button to enter "operation ready" status.
Operation ready status "0000" is displayed instead of "E000".
That's to say, the inverter is in normal stop status and can be
operated if required. (Operation Status Display Mode)
This function cannot be used during operation.Be sure to use it in stop status.
During the selection of built-in memory setting mode display, the inverter will
not start operation even if an operation signal enters. And only after selection
completion (i.e., with "OFF" or "ON" displaying) and SET button is pressed, the
inverter will enter "operation ready" status.
8. Setting Modes and Copy Functions of Built-in Memory
button to select "CPY4".