Coast-To-Stop Function - Panasonic VF200 Instruction Manual

Appendix Function Parameter List

■ Coast-to-stop Function

The signal input terminal for applying coast-to-stop through external control
can be set.
・During operation, the inverter will stop output immediately after signal input
is turned ON and "0.0" is displayed.
(without fault indication and fault alarm output)
・The inverter will run immediately after signal input is turned OFF and run
signal is turned ON.
[Note] The inverter will start as the signal is turned OFF, so please ensure
personal safety before operation.
・The inverter will stop normally after the run signal is turned OFF together
with signal input being turned OFF.
< Example > When SW1 (parameter P036 = 6) is set to coast-to-stop and
run command select (parameter P003 = 2) is used
178