Chapter 3
3.1 Points to Note About Installation
3.1.1 Points to Note on Installation
0007-7622
Caution
1. The following options are required to install the security kit: PCI Bus Expansion Kit-B1,
USB Application Interface Board-D1, and iR256MB Expansion RAM-B1 (except 120V
model)
Be sure to attach these options beforehand. If these are not attached, a license key fails to
be registered appearing the message, "There are not enough required features for install".
2. User data in the hard disk is deleted in the cases below.
- When registering a license key of the security kit to enable the security functions.
- When re-generating a data encryption key.
- When invalidating a license of the security kit to stop security operation.
Inform a person in charge of user's device administration that the data shown below is all
deleted if any of the actions above is taken, and induce user to backup necessary data. In the
light of security, a service person should not backup user's data.
For reference, a backup procedure is shown in this manual.
Data to be deleted
- Data stored in the Mail boxes
- Address information registered to address book
- Scan settings registered using the transmission function
- Mode memory registered using the copy function/box function
- MEAP applications and license files
- Data stored using any of MEAP applications
- Service Management Service (SMS) Password of MEAP
(If user changed the password, it is returned to a factory default.)
- User authentication information registered in SDL (Simple Device Login)
- Yet-to-be-transmitted documents (i.e., documents of timer transmission/being reserved
for transmission)
- Job history information
- Settings made in user mode
3-1