Ricoh D069 Field Service Manual page 463

Monitor speaker during memory
transmission
2
0: Disabled 1: Enabled
3-7 Not used
G3 Switch 01 [SP No. 1-105-002]
No FUNCTION
0-3 Not used
DIS frame length
4
0: 10 bytes 1: 4 bytes
5 Not used
Forbid CED/AMsam output
6 0: Off
1: On (Forbid output)
7 Not used
G3 Switch 02 [SP No. 1-105-003]
No FUNCTION
G3 protocol mode used
0 0: Standard and non-standard
1: Standard only
1-6 Not used
Short preamble
7
0: Disabled 1: Enabled
G3 Switch 03 [SP No. 1-105-004]
No FUNCTION
1: The monitor speaker is enabled during memory
transmission.
Do not change the settings.
COMMENTS
Do not change the settings.
1: The bytes in the DIS frame after the 4th byte will not be
transmitted (set to 1 if there are communication problems
with PC-based faxes which cannot receive the extended
DIS frames).
Do not change the setting.
Do not change this setting (Default: 0: Off), unless
communication problem is caused by a CED or ANSam
transmission.
Do not change the setting.
COMMENTS
Change this bit to 1 only when the other end can only
communicate with machines that send T.30-standard
frames only.
1: Disables NSF/NSS signals (these are used in non-
standard mode communication)
Do not change the settings.
Refer to Appendix B in the Group 3 Facsimile Manual for
details about Short Preamble.
COMMENTS
Bit Switches
7
271