Ricoh D069 Field Service Manual page 441

No FUNCTION
TTI printing position
0: Superimposed on the page data
0
1: Printed before the data leading
edge
1 Not used
2-7 Not used
System Switch 12 [SP No. 1-101-019]
No FUNCTION
TTI printing position in the main scan
0-7
direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No FUNCTION
0 Not used
Going into the Energy Saver mode
automatically
1
0: Enabled
1: Disabled
2-3 Not used
COMMENTS
Change this bit to 1 if the TTI overprints information that the
customer considers to be important (G3 transmissions).
Japan Only
Do not change the factory settings.
COMMENTS
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI from
the left edge of the paper. If the TTI is moved too far to the
right, it may overwrite the file number which is on the top
right of the page. On an A4 page, if the TTI is moved over
by more than 50 mm, it may overwrite the page number.
COMMENTS
Do not change the settings.
1: The machine will restart from the Energy Saver mode
quickly, because the +5V power supply is active even in the
Energy Saver mode.
Do not change these settings.
Bit Switches
7
249