Ricoh D069 Field Service Manual page 444

7. Appendix: Fax Service Program (Only For D068/D069)
No
RTI/CSI/CPS code display
0 0: Enable
1: Disable
1 Not used
Destination telephone number
display limitation
2
0: OFF, 1: ON
Operation selection without PIN
code registered
3
0: Transmission interrupted
1: No interrupted transmission
4-7 Not used
System Switch 1E [SP No. 1-101-031]
7
No
Communication after the Journal
data storage area has become full
0
0: Impossible
1: Possible
Action when the SAF memory has
become full during scanning
1
0: The current page is erased.
1: The entire file is erased.
252
FUNCTION
0: RTI, CSI, CPS codes are displayed on the top line of the
LCD panel during communication.
1: Codes are switched off (no display)
Do not change this setting.
When "1" is selected, the destination telephone number
display is limited and redial is disabled.
0: When "0" is selected without PIN code registration,
transmission is interrupted and an alert message shows on
the LCD.
Do not change these settings.
FUNCTION
COMMENTS
COMMENTS
0: When this switch is on and the journal history becomes
full, the next report prints. If the journal history is not deleted,
the next transmission cannot be received. This prevents
overwriting communication records before the machine can
print them.
1: If the buffer memory of the communication records for
the Journal is full, fax communications are still possible. But
the machine will overwrite the oldest communication
records.
Note: This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the report
(e.g., no paper).
0: If the SAF memory becomes full during scanning, the
successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning, the file
is erased and no pages are transmitted.
This bit switch is ignored for parallel memory transmission.