Ricoh D069 Field Service Manual page 437

Length of time that RDS is
temporarily switched on when bits 6
0-7
and 7 of System Switch 02 are set
to "User selectable"
System Switch 04 [SP No. 1-101-005]
No FUNCTION
0-2 Not used
Printing dedicated tx parameters on
Quick/Speed Dial Lists
3
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION
0 Not used
Inclusion of communications on the
Journal when no image data was
1
exchanged.
0: Disabled 1: Enabled
Automatic error report printout
2
0: Disabled 1: Enabled
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System Switch 02
are set to "User selectable".
The default setting is 24 hours.
COMMENTS
Do not change these settings.
1: Each Quick/Speed dial number on the list is printed with
the dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated
tx parameters; 34 bytes of data are printed (the other 24
bytes have no use for service technicians).
Do not change these settings.
COMMENTS
Do not change these settings.
0: Communications that reached phase C (message tx/rx)
of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call setup) of T.
30 protocol are listed on the Journal. This will include
telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
Bit Switches
7
245