Ricoh D069 Field Service Manual page 416

6. Appendix: Fax Troubleshooting Guide (Only For D068/D069)
Code
Repeated Destination
15-81
Registration Error
15-91 Send Registration Error
15-92 Memory Overflow
15-93 Memory Access Error
6
15-94 Incorrect ID Code
15-95 Transfer Station Function
Original length exceeded the
22-00
maximum scan length
Memory overflow while
22-01
receiving
Tx or rx job stalled due to line
22-02
disconnection at the other end
224
Meaning
• Could not repeat receive the transmission because the
Could not receive the file for transfer to the final destination:
• The format of the final destination or the transfer
• Destinations are full so the final and transfer
• Transmission could not be received because memory
• Transaction could not complete due to a malfunction
• The machine rejected an incoming e-mail for transfer
• The machine rejected an incoming e-mail for transfer
• Divide the original into more than one page.
• Check the resolution used for scanning. Lower the scan
• Add optional page memory.
• Wait for the files in the queue to be sent.
• Delete unnecessary files from memory.
• Transfer the substitute reception files to an another fax
• Add an optional SAF memory card or hard disk.
• The job started normally but did not finish normally;
• Restart the machine.
Suggested Cause/Action
destination buffer is full and the destination could not
be created (this error may occur when receiving a
transfer request or a request for notification of
reception).
destination is incorrect.
destinations could not be created.
overflowed during the transaction.
of SAF memory.
request, because the ID code in the incoming e-mail
did not match the ID code registered in the machine.
because the transfer function was unavailable.
resolution if possible.
machine, if the machine's printer is busy or out of order.
data may or may not have been received fully.