Ricoh D069 Field Service Manual page 380

5. Appendix: SP Mode Tables
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120* Clear-OP Count Remove
Specifies the condition to reset the copy job settings when the key counter is removed.
• 0: Y = Yes: The settings are cleared when the counter is removed.
• 1: StdBy = Standby only: The settings are cleared when the counter is removed at the
5120 1
• 2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these setting.
5121* Count Up Timing
5
Selects the count-up timing.
5121 1 • 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5501* PM Alarm Interval
5501 1 Printout
5801 Memory Clear (basic model only)
5801 2 Engine (
5802 Machine Free Run
Conducts machine free run (including the scanner unit). Press "ON" to start; press "OFF"
5802 1
to stop.
Input Check
5803
Output Check
5804
188
end of a job.
"Memory Clear" in this section)
"Input Check" in this section.
"Output Check" in this section.
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[0 to 9999 / 0 / 1K copies/step]
Specifies when the PM alarm occurs.