Ricoh D069 Field Service Manual page 445

RTI/CSI display priority
2
0: RTI 1: CSI
File No. printing
3 0: Enabled
1: Disabled
Action when authorized reception is
enabled but authorized RTIs/CSIs
are not yet programmed
4
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
5-7 Not used
System Switch 1F [SP No. 1-101-032]
No FUNCTION
0 Not used
Report printout after an original jam
during SAF storage or if the SAF
memory fills up
1
0: Enabled
1: Disabled
2 Not used
Received fax print start timing
(G3 reception)
3
0: After receiving each page
1: After receiving all pages
4-6 Not used
This bit determines which identifier, RTI or CSI, is displayed
on the LCD while the machine is communicating in G3 non-
standard mode.
1: File numbers are not printed on any reports.
If authorized reception is enabled but the user has stored
no acceptable sender RTIs or CSIs, the machine will not be
able to receive any fax messages.
If the customer wishes to receive messages from any sender
that includes an RTI or CSI, and to block messages from
senders that do not include an RTI or CSI, change this bit to
"1", then enable Authorized Reception.
Otherwise, keep this bit at "0 (default setting)".
Do not change the settings
COMMENTS
Do not change the settings.
0: When an original jams, or the SAF memory overflows
during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to have
a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
Do not change the factory settings.
Bit Switches
7
253