Ricoh D069 Field Service Manual page 105

5. Slide the 1st and 2nd scanners so that all four of the following are roughly aligned on both the front
and back sides:
• The hole in the copier's lid
• The hole in the 1st scanner
• The right corner hole in the 2nd scanner
• The hole at the base of the scanner
6. Insert the two optics adjustment tools [A], and adjust the scanners as necessary so that the tools go
through all four holes.
7. Tighten the two screws that you loosened at step 2 above, so that the belts are firmly clamped into
place.
8. Remove the adjustment tools.
Scanner Unit
4
103