Ricoh D069 Field Service Manual page 372

5. Appendix: SP Mode Tables
Adjusts the side-to-side registration for scanning in platen mode (
4011 1
Area" in the section "Replacement and Adjustment").
4012* Scan Erase Margin
4012 1 Leading edge
4012 2 Trailing edge
4012 3 Left Side
4012 4 Right Side
4013 Scanner Free Run
5
4013 1 Conducts the scanner free run with the exposure lamp on.
4015* White Plate Scan
Start position
4015 1
Adjusts the scanning start position on the white plate. The base value is 17.8 mm from the
scanner home position. This SP specifies the offset from this base value.
Scanning Length
Adjusts the distance of the white plate scan. The scan begins from the start position
4015 2
(SP4-015-001) and ends at the specified distance. The base value is 2.0 mm. This SP
decides the offset from this base value. Specify 0 (zero) or a larger value.
4428 Scan Auto Adjustment
Conducts the automatic scanner adjustment. Use this SP after replacing the white plate
4428 1
(
4450 Image Path
BK Offset Enable
001
Uses or does not use the black reduction image path.
SH Path Enable
002
Uses or does not use the shading image path.
180
"Scanning" in the section "Replacement and Adjustment").
[0 to 9.0 / 1.0 / 0.1 mm/step]
Adjusts the scanning margin. Generally, the scanning
margin should be as little as possible. To adjust the image
area, use SP2-101.
[–3.0 to +6.0 / 0.0 / 0.1 mm/step]
[–3.0 to +6.0 / 0.0 / 0.1 mm/step]
[0 or 1 / 1 / - ] 0: OFF, 1: ON
[0 or 1 / 0 / 1 /step] 0: No, 1: Yes
"Adjusting Copy Image