Ricoh D069 Field Service Manual page 436

7. Appendix: Fax Service Program (Only For D068/D069)
Protocol dump list output after each
communication
6
0: Off
1: On
7 Not used
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 [SP No. 1-101-003]
No
0-1 Not used
Force after transmission stall
2 0: Off
7
1: On
3-5 Not used
Memory read/write by RDS
Bit 7: 0, Bit 6: 0
Always disabled
Bit 7: 0, Bit 6: 1
6-7 User selectable
Bit 7: 1, Bit 6: 0
User selectable
Bit 7: 1, Bit 6: 1
Always enabled
System Switch 03 [SP No. 1-101-004]
No
244
FUNCTION
FUNCTION
This is only used for communication troubleshooting. It
shows the content of the transmitted facsimile protocol
signals. Always reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only printed if
there was an error during the communication.
Do not change the setting.
COMMENTS
Do not change these settings.
With this setting on, the machine resets itself automatically
if a transmission stalls and fails to complete the job.
Do not change these settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but the
user can temporarily switch RDS on to allow RDS operations
to take place. RDS will automatically be locked out again
after a certain time, which is stored in System Switch 03.
Note that if an RDS operation takes place, RDS will not
switch off until this time limit has expired.
(1,1): At any time, an RDS system can access the machine.
COMMENTS