Setting Up The 9493™ Using Direct Serial Connections - Avery Dennison Monarch 9493 SNP Administrator's Manual

S e t t i n g u p t h e 9 4 9 3 ™ U s i n g D i r e c t S e r i a l C o n n e c t i o n s
Use a serial cable or a USB cable for direct communication with the printer.
The USB port can function as either a serial port or a parallel port. Refer to
the System Administrator's Guide for more information about changing the
USB port's function.
1. Open the hinged cable door on the side of the
printer by loosening the two screws with a
Phillips screwdriver.
2. Plug the DB9 connector into the DB9 port or plug
a USB type A or USB mini-B connector into the
corresponding USB port as show.
3. Place the cable in one of the cable cavities.
4. Turn on the printer and configure using Telnet
or other communications program. See Chapter
6, "Telnet Console Commands" for more
information.
Turn off the printer, wait a few seconds, and
5.
then turn on the printer.
Your printer is ready to use.
2-4 System Administrator's Guide
DB9 cable show n
USB mini-B cable show n