Avery Dennison Monarch 9493 SNP Administrator's Manual page 26

Setting the Command Escape Character
This option allows you to set or view the Command Escape Character (CEC).
Run-time messages from the radio begin with the CEC and the default is the
pound sign (#), which has a decimal value of 35. You may need to change
the default CEC character if it conflicts with other data, because an
unexpected operation could occur. The range is a decimal value between 1
and 255.
From the Configure menu, select Escape.
1.
Escape Char
+ 35
E R
Use A as shown in the following table:
E
Press A to
Saves the setting
When the setting you want is displayed, press E to save the setting.
2.
You return to the Configure menu.
Press F to exit.
3.
When you select "Exit" after configuring, you will see
Configure
Save Settings?
E
To save all the configuration settings, press E. To exit without saving the
configuration settings, press X . Press F until you see "Ready."
Note: You must reset the RF network before your changes take effect.
See "Resetting the RF Network" for more information.
2-14 System Administrator's Guide
+
R
Press A to
Scrolls through the
positions from left to right
X
+
Press A to
Increments the current
position setting by 1