Configuring Network Protocols - Avery Dennison Monarch 9493 SNP Administrator's Manual

C o n f i g u r i n g N e t w o r k P r o t o c o l s
Only configure the settings required for your network/printer. To enable or
disable protocols:
1. From the side menu, click Admin. The Web Admin Configuration screen
appears.
2. Click Protocol Control.
Enable or disable your network protocols and IP protocols.
3.
Note: If you disable the TCP/IP protocol, all IP protocols are disabled
automatically.
4. Click Submit.
5. Click the reset link at the bottom of the screen. The Reset Server screen
appears.
6. Click Submit and wait five seconds for the print server to reset.
Even though you submitted your changes, they do not take effect until
you reset the print server.
You must re-enter your access password to make any further changes to
the printer settings.
4-18 System Administrator's Guide