Setting Supply Options - Avery Dennison ADTP1 System Administrator Manual

S E T T I N G S U P P L Y O P T I O N S
This chapter explains how to select the supply type, ribbon, speed, feed mode, cut
mode, backeed, print position, supply position, margin position, cut position, dispense
position, backfeed distance, separators, skip index mode, rotate image, maximum
calibration length, and print contrast.
You may limit access to this menu to prevent changes by the users. Users are prompted
to enter a password when password protection is enabled.
The supply options are listed in the table below.
Option
Supply Type
Ribbon
Speed
Feed Mode
Cut Mode
Backfeed
Print Position
Supply Position
Margin Position
Cut Position
Dispense Position
Backfeed Distance
Separators
Skip Index
Error Action
Rotate Image
Maximum
Calibration Length
Contrast
Press CANCEL to exit an option without changing the setting.
Choices
E Aperture/E Die Cut/E Black Mark/Continuous/ C
Aperture/C Die Cut/C Black Mark/C Tag Edge
No/Yes/High Energy
2.5/4.0/6.0/8.0/10.0/12.0/Default
Continuous/On-Demand/Liner Takeup
Disabled/Cut Each Tag/Cut Each Batch/
Mode 3/Mode 4/Mode 5/Mode 6
Off/On
-450 to 450
-300 to 300
-99 to 99
-300 to 300
50 to 200
10 to 200
No/Yes/Long
No/Yes
Normal
Overstrike/Continue 1x – 5x
No/Yes
0 to 6902 (203 dpi = 34 inches)
-699 to 699
Classification: Avery Dennison – Public
Default
E Die Cut
Yes
Default
Continuous
Disabled
Off
0
0
0
0
65
65
No
No
Normal
No
3552
0

Setting Supply Options 2-1

2