Setting Up The 9460™ Using Direct Serial Connections; Setting Up The 9493™ Using Direct Serial Connections - Avery Dennison Monarch 9460 SNP System Administrator Manual

S e t t i n g U p t h e 9 4 6 0 ™ U s i n g D i r e c t S e r i a l C o n n e c t i o n s
1. Disconnect the printer's radio cable from the printer's serial port.
2. Connect a serial cable (straight-through DB9 female to DB9 female) from the host or
computer to the print server's radio cable.
3. Turn on the printer and configure using Telnet or other communications program. See
Chapter 6, "Telnet Console Commands" for more information.
4. Connect the printer's radio cable to the printer's serial port.
Serial Port
5. Turn off the printer, wait a few seconds, and then turn on the printer. Your printer is
ready to use.
S e t t i n g u p t h e 9 4 9 3 ™ U s i n g D i r e c t S e r i a l C o n n e c t i o n s
Use a serial cable for direct communication with the
printer.
1. Open the hinged cable door on the side of the printer by
loosening the two screws with a Phillips screwdriver.
2. Plug the null modem DB9 connector into the DB9 port as shown.
3. Place the cable in one of the cable cavities.
4. Turn on the printer and configure using Telnet or other
communications program. See Chapter 6, "Telnet Console
Commands" for more information.
5. Turn off the printer, wait a few seconds, and then turn on the printer. Your printer is
ready to use.
2-2 System Administrator's Guide
Radio Cable
Radio Cable
DB9 cable show n