Setting Up Using The Printer's Menu; Setting Up The 9460™ Printer - Avery Dennison Monarch 9493 SNP Administrator's Manual

♦ To use TCP/IP without a DHCP server, manually assign a valid IP
address, subnet mask, and gateway and then set the boot method to
static.
Note: If you are using DHCP on your network, the print server may have
acquired valid IP settings at this point and no further configuration is
necessary. This works if your DHCP server allows the print server to
keep this address permanently. However, in most cases, use a static
address outside the range reserved for DHCP (Refer to your DHCP
server documentation for details). When you configure your printer
port, it goes to a static IP address.
When you are done configuring, click OK. You are prompted to save
7.
changes and reset the print server. Click OK. The print server resets with
your new configuration. This may take several minutes.
S e t t i n g U p U s i n g t h e P r i n t e r ' s M e n u
You can use the printer's menu to configure some basic network settings.
Follow the instructions for your printer: 9460 or 9493.
S e t t i n g U p t h e 9 4 6 0 ™ P r i n t e r
Use these instructions to set up a 9460 printer using the printer's RF
Network menu in the printer's Tool Box.
Turn on the printer by pressing and holding the power button (P) until
1.
the display turns on.
The display flashes printer version information and battery charging
status.
E B
Init Radio..........
When you see "Init Radio", the printer is waiting for the wireless print
server to initialize.
Next, you may see
Ready
p
<T>
2-6 System Administrator's Guide
F