Remote Admin - LevelOne wbr-3408 User Manual

Remote Admin

If enabled, this feature allows you to manage the Wireless Router via the Internet.
Data - Remote Administration Screen
Remote Administration
Enable Remote
Management
Port Number
Current
IP Address..
Figure 52: Remote Administration Screen
Check to allow administration/management via the Internet. (To
connect, see below).
If Disabled, this device will ignore Administration connection
attempts from the Internet.
Enter a port number between 1024 and 65535. The default for
HTTP (Web) connections is port 80, but using port 80 will
prevent the use of a Web "Virtual Server" on your LAN. So
using a different port number is recommended. The default
value is 8080.
The port number must be specified in your Browser when you
connect. To specify the port number :
1. From a remote location, start your Browser.
2. In the "Address" or "Location" field, enter the Internet IP
address of this device (NOT the LAN IP address), followed
by the port number, as follows:
http://ip_address:port_number
Where:
ip_address is the Internet IP address of this device.
port_number is the port number assigned on this screen.
3. You should then be prompted for the password for this
device. (You must assign a password!)
To manage this device via the Internet, you need to know the
IP Address of this device, as seen from the Internet. This IP
Address is allocated by your ISP, and is shown here. But if
using a Dynamic IP Address, this value can change each time
you connect to your ISP. There are 2 solutions to this problem:
89
Advanced Administration