Skoda Octavia Workshop Manual page 107

OCTAVIA
Edition 10.99
S00.5104.53.20
Cooling System
Coolant additives from the Škoda Genuine Parts
List conforming to Specification TL VW 774 D:
Coolant additives
Glysantin G30-72
XT 4030
Coolant ETX 6280
FROSTOX SF-D 12
Note:
The coolant additives stated can be intermixed.
Recommended mixing ratios:
Antifreeze
protection
down to
-25 °C
-35 °C
Do not exceed an antifreeze concentration
1)
of 60 %; antifreeze protection and cooling
efficiency are reduced at higher con-
centrations.
Coolant quantity may vary depending on
2)
equipment of vehicle.
- Screw in drain plug for coolant.
K - Pour in coolant up to „max“ marking on
expansion reservoir.
- Start engine, run for not more than 2 minutes
at about 1500 rpm and at the same time pour
in coolant up to the overflow hole at
expansion reservoir.
- Close expansion reservoir.
- Run engine until the fan cuts in.
- Inspect coolant level. When engine is at
normal operating temperature, the coolant
level must be at the max. marking; when
engine is cold, it must be between the min.
and max. markings. Top up coolant, if
necessary.
Warning!
Hot steam may escape when the expansion
reservoir is opened. Place cleaning rags around
cap with and open carefully.
Manufacturer
BASF AG
ELF OIL AG
TEXACO
HENKEL HAERTOL GmbH
Antifreeze
concentration
1)2)
40 % (2.0 ltr.) 60 % (3.0 ltr.)
50 % (2.5 ltr.) 50 % (2.5 ltr.)
------------ 19-4.1 ------------
19
Water
2)